Stamping die parts in the design requirements

In order to ensure the normal production and reduce the risk of stamping die defects caused by the trouble, the following proposed stamping die in the design requirements.

1. Stamping die in the working parts, such as concave and convex mold material must ensure that the hardness, strength, heat treatment to meet the requirements, to prevent the use of fracture.

2. Stamping die positioning parts designed to facilitate the operation, the use of a reasonable positioning.

3. Pressure plate, pressure ring design should meet its specific function, the ejector need to have a certain out of force, to meet the workpiece and clean up the residual material function. Discharge design to prevent finger into the corner to be rounded, to avoid scratching your fingers.

4. Guide column guide sleeve design not only to meet the concave and convex die in the work of the gap needs, and to avoid the staff without crossing the guide column to get blank.

5. Stamping die pad design should be connected with the template through the screw nut, the distance between the two should be able to facilitate the parts as a standard.

6. The design of the fastener should take into account the ease of operation and the safety of bruising.